Vl300 advanced driver

Moderators: Martin , bradders , Steve , Mr Magoo. Post by petereggington » Tue 15 May , pm. Post by bradders » Thu 17 May , am.

Post by Denford Admin » Thu 17 May , pm. Post by petereggington » Sat 19 May , am. Post by petereggington » Sat 19 May , pm. Post by bradders » Mon 21 May , am. Post by Denford Admin » Mon 21 May , am. Post by petereggington » Mon 21 May , pm. Post by Martin » Mon 21 May , pm.

Search Advanced search. Quick links. Search Advanced search. Quick links. If I'm cutting 3mm, 6mm, 9mm perspex or engraving onto the same thickness wood the laser is fine.

However, one of our students wanted a name engraving on a box he made which is 29mm thick. In 2D Design, I specify the material thickness for a simple engraving but the laser honeycomb bed doesn't compensate for this thickness.

When ULS's chemical and HEPA filtration system is used, it too is computer-controlled and is turned off and on automatically by the software to limit noise and energy use. This makes it impossible for operators to run the laser without the ventilation system operating properly. No filtration, no laser and no way for the typical user to bypass this safety feature. I tested the laser using this system and found it more than adequate for everything I did.

For operations in malls or other areas where an external exhaust is not practical or where the laser needs to be portable, the filtration system is the best solution.

Although its built-in blower adds to the noise of the laser, the sound level is still low enough to allow talking on the phone when you sit next to it. If one opts to use conventional venting, a special stand can be purchased to place the laser on or it can sit on a desk or table remember, the system weights about pounds so be sure to use a sturdy table. Specs call for an exhaust system capable of CFM which can be installed for a few hundred dollars.

As with all lasers, proper ventilation and exhaust are imperative. As power comes from the laser tube, it can be measured to be 30, 40 or 50 watts, depending on the model laser being tested.

A CO 2 laser light beam from a typical laser is then focused down to a tiny spot usually about. If the light beam could be focused into an even smaller dot, say down to about. What HPDFO does is solve this problem by directing the laser beam through a series of special mirrors optics in such a way as to condense the spot size down to about. The nature physics of a CO 2 laser beam resists being condensed down below. Up to now, to go any smaller would be both very expensive and technologically challenging.

HPDFO is not a single lens, nor an amplifier or magnifier. Rather, it's an assembly of mirrors and lenses that takes the laser beam and refocuses it into a smaller beam of light. The light beam is reflected by a combination of mirrors and refracted by the lenses and the beam is then compressed and intensified into a smaller, more dense beam spot. Where normally more mirrors and lenses reduce the laser beam's effective power, the special optic lens is designed so it intensifies the light beam by condensing the available laser power into a smaller spot.

The smaller the spot, the higher the power density. And concentrated power is what you need to mark metals. NVIDIA does extensive testing which focuses on the top creative applications and ensures the highest levels of performance, stability, and functionality are provided. This driver is most commonly deployed at enterprises, providing support for the sustained bug fix and security updates commonly required. Production Branch drivers offer ISV certification, long life-cycle support, and access to the same functionality as corresponding Studio Drivers of the same version.

Click the Search button to perform your search.